ZC swap - worried

[Digitalcivic]

Ok guys, I got a couple more days before I attempt the dx/zc swap.

I have the engine, zc ecu, 3 ecu plugs from a 87 rex si (for the extra pins), injector resistor box.
I plan on replacing the timing belt and water pump too. They said the TPS sensor is ususally broke after shipping. Where do I get a new TPS sensor. I heard you have to buy a whole new throttle body.

I'm pretty worried about this swap. What if I start and cant do it. How hard is the wiring part of it.

Any help, tips, comments,

Joe

[tweederzc]

i just bitched out and bought a pre wired harness from HASport but mine was a std. model so there was mad wiring to be done anyways i just completed my zc swap so if ya run into any problems hit me up....

[NC_Rex]

ARD performance also makes harnesses for the 4G models. I think ARD.com

CORRECTION: http://www.ardperformance.com, goto JDM Engines, goto What Motoro Mounts...Harnesses are there.

[This message has been edited by NC_Rex (edited August 18, 2001).]